In Stock & Ready to Freight Outboard Motors

Honda 20HP Portable Outboard | BF20D3SH

Brand: Honda
Condition: New
€4,042.98
Freight included, insured road freight within the UK & Europe (rates)
€4,042.98 delivered across UK & Europe
  • ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
  • Insured European road freight delivery with hydraulic tail-lift service
  • Dispatches in 1–2 business days from our UK & European Logistics Centre
  • Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Ask a question about this unit

Need a matched transmission, controls or wiring package? Speak with a parts specialist.

Details & Inspection Notes

At 103 pounds, this Honda BF20D3SH is the lightest build in this group of 20 hp listings, carrying a 15-inch short shaft, tiller steering, and manual start rather than the longer shaft or added electrics found elsewhere in Honda's lineup. The 350cc, two-cylinder engine is carbureted, its rev range topping out near 6000 rpm once full throttle opens around 5000.

What to check before buying

Fifteen inches is the short-shaft option, meant for a lower transom than a long-shaft 20 hp motor would need; measure before ordering rather than assuming it fits a taller hull. With manual start and tiller steering, there's no battery or remote console to wire in anywhere on this build.

What comes with it

The motor arrives with a propeller, a charging circuit, an outside tank good for 3 gallons feeding through its own line, and a lanyard-style stop switch, topped off with the printed manual.

Keeping it running

A motor this small is easy to store off-season: run the tank down or add stabilizer before putting it away, since a gummed-up carburetor from stale fuel is the most common complaint on small portable outboards left sitting over winter.

Is a battery needed to start this motor? No, starting is by manual pull cord. What's the shaft length? 15 inches, the short option here. Does it have shallow water drive? Yes.

Startup & Installation Checklist

  • Inspect all external gaskets, seals, spark plugs and timing components prior to installation.
  • Refill engine oil, transmission gear oil and coolant to manufacturer-specified capacities before initial cranking.
  • Prime the lubrication system and verify ECU wiring pinouts, sensors, and ground connections.
  • Startup warranty covers internal lubricated components, cylinder heads, and engine block for 30 days from delivery.

Full terms: 30-day startup warranty · returns