In Stock & Ready to Freight Outboard Motors

Yamaha 50HP 2 Stroke Short Shaft 50HMHOS

Brand: Yamaha
Condition: Used
€2,460.36
Freight included, insured road freight within the UK & Europe (rates)
€2,460.36 delivered across UK & Europe
  • ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
  • Insured European road freight delivery with hydraulic tail-lift service
  • Dispatches in 1–2 business days from our UK & European Logistics Centre
  • Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Ask a question about this unit

Need a matched transmission, controls or wiring package? Speak with a parts specialist.

Details & Inspection Notes

This used 2011 Yamaha 50HMHOS is a short-shaft, 50 hp two-stroke outboard pulled from fresh water with no corrosion on the housing. Compression tested at 120 psi across all three cylinders on this unit, the exterior shows no scratches, and the seller describes it as original and unmodified.

What to check before buying

Yamaha offers the 50HMHOS in more than one shaft length, so confirm short-shaft fits your transom before you buy this exact unit, since a shaft swap afterward is not practical. Lubrication is by oil injection rather than pre-mixed fuel, three carburetors feed the engine, and full throttle runs from 4500 to 5500 rpm. A 6-amp alternator at 12 volts handles basic electrical loads on this motor.

Condition

Low hours paired with a fresh-water history are the standout points on this short-shaft 50HMHOS next to a typical used two-stroke of this age. The gear ratio is 1.85, trim and starting are both manual, and the crated shipping weight comes to 158 lbs against a dry weight of 75.0 kg. Ask about recent fuel-system service on any two-stroke this age before running it hard, and plan to top off the oil-injection reservoir before the first outing.

Common questions

Has this engine been altered from stock? No, the seller describes this 50HMHOS as all original.

Does the compression test look healthy? Yes, all three cylinders tested at 120 psi.

Startup & Installation Checklist

  • Inspect all external gaskets, seals, spark plugs and timing components prior to installation.
  • Refill engine oil, transmission gear oil and coolant to manufacturer-specified capacities before initial cranking.
  • Prime the lubrication system and verify ECU wiring pinouts, sensors, and ground connections.
  • Startup warranty covers internal lubricated components, cylinder heads, and engine block for 30 days from delivery.

Full terms: 30-day startup warranty · returns