Evinrude E75DPGL Outboard Motor

This used 2020 Evinrude E75DPGL is a 75-hp, three-cylinder E-TEC outboard with graphite-finish controls, electric start, and remote steering that can take an optional tiller accessory.

Engine output

This three-cylinder block displaces 79 cubic inches, full throttle falls somewhere in the 5,000-5,500 rpm range, and the primary gearcase runs 2.00:1. A Trac-1 unit takes care of the power trim and tilt side of the rigging, rather than a manual lever at the stern of the boat.

Specs to confirm before ordering

This unit weighs 320 lbs on a 20-inch shaft, so check that length against your boat's transom first. Graphite control finish is worth noting if you're matching existing rigging elsewhere on the boat, since this same engine also ships with white controls as an alternative.

Model year and service life

Being built in 2020, this sits among the newer used units within Evinrude's 75-hp three-cylinder line, a point that often matters more than headline specs once you're comparing remaining service life against older stock.

Who a 75-hp three-cylinder suits

This horsepower and cylinder count commonly shows up on mid-size runabouts, pontoons, and center consoles where three-cylinder smoothness is preferred over the lighter but rougher-running two-cylinder motors lower in Evinrude's lineup.

What model year is this? 2020.

Is this a tiller or remote-steer motor? Remote steering, with a tiller accessory listed as available.