In Stock
2020 Yamaha 4 HP F4LMHA Outboard Motor
incl. 21% VAT (Spain) · change country
United Kingdom · Ireland · Germany · France · Netherlands · Belgium · Spain · Italy · Portugal · Austria · Czech Republic · Poland · Sweden · Denmark · Finland · Greece · Hungary · Romania · Slovakia · Switzerland · Norway
- ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
- Insured European road freight delivery with hydraulic tail-lift service
- Dispatches in 1–2 business days from our UK & European Logistics Centre
- Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Need a matched transmission, controls or wiring package? Speak with a parts specialist.
Details & Inspection Notes
The 2020 Yamaha F4LMHA is a 4 hp, single-cylinder four-stroke portable on the long, 20-inch shaft, manual-started, built around a compact 139cc engine rated at 4hp at 4500rpm. At 61 pounds it suits small dinghies and tenders where a taller transom and easy carrying both matter.
Why long shaft here
This is the 20-inch version, meant for a taller transom than Yamaha's short-shaft 15-inch F4 sibling; mounting it on a lower transom would leave the motor sitting too deep. Starting is manual pull-cord only, so there's no battery or wiring to install.
Under the cowling
Bore and stroke measure 62 by 46mm, compression runs at an 8.9:1 ratio, and the overhead-valve design revs through a 4000-5000rpm full-throttle band. Cooling is water-based with thermostatic control, lubrication is wet sump, and trim adjusts across five positions with up to 69 degrees of tilt.
Upkeep
Yamaha specifies regular unleaded fuel at a minimum 87 octane, Yamalube 4M oil at a .6L fill, spark plug CR6HSB, a 17mm prop nut, and an 8mm fuel hose.
Carrying it around
A motor this size gets moved by hand far more often than a bigger outboard ever does, so drain the carburetor float bowl before laying it on its side in a car trunk or storage locker, rather than assuming a sealed cap keeps fuel from seeping out.
Common questions
Does it need a battery? No, starting is manual pull-cord only, and this unit is sold new.
Startup & Installation Checklist
- Inspect all external gaskets, seals, spark plugs and timing components prior to installation.
- Refill engine oil, transmission gear oil and coolant to manufacturer-specified capacities before initial cranking.
- Prime the lubrication system and verify ECU wiring pinouts, sensors, and ground connections.
- Our 2-year warranty covers internal lubricated components, cylinder heads and engine block from delivery, in addition to your statutory rights.
Full terms: 2-year warranty · returns