In Stock
2019 Yamaha 8 HP F8SMHB Outboard Motor
excl. VAT – import VAT and duties are payable on delivery to Norway · change country
United Kingdom · Ireland · Germany · France · Netherlands · Belgium · Spain · Italy · Portugal · Austria · Czech Republic · Poland · Sweden · Denmark · Finland · Greece · Hungary · Romania · Slovakia · Switzerland · Norway
- ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
- Insured European road freight delivery with hydraulic tail-lift service
- Dispatches in 1–2 business days from our UK & European Logistics Centre
- Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Need a matched transmission, controls or wiring package? Speak with a parts specialist.
Details & Inspection Notes
Built on a 15-inch shaft rather than the longer option Yamaha offers on this platform, the 2019 Yamaha F8SMHB is an 8 hp two-cylinder four-stroke weighing 87 lbs. The F8SMHB runs a carbureted 212cc block with a 9.46:1 compression ratio and a 12-volt, 6-amp alternator.
Who it suits
Smaller aluminum boats, inflatables and dinghies with a lower transom are the fit for the F8SMHB's 15-inch shaft, and the twin-cylinder design keeps the whole package light enough to carry by hand between a boat and a vehicle rather than hoisting it with gear. Its wet-sump lubrication also means no separate oil mixing before each outing.
Before you order
The F8SMHB ships with manual starting, though an electric starter kit is available as an option if you would rather not pull-start it. Confirm 15 inches is correct for your transom, since Yamaha also sells a longer-shaft version of this same engine under a separate listing.
Common questions
Can electric start be added later? Yes, an electric starter kit is offered as an accessory for the F8SMHB.
What fuel does it take? Regular unleaded with a minimum 87 octane rating.
Is the F8SMHB fuel injected? No, this one runs on a carburetor instead of EFI.
Is the F8SMHB heavier or lighter than the long-shaft version? Lighter; the F8SMHB weighs 87 lbs on its shorter shaft.
Startup & Installation Checklist
- Inspect all external gaskets, seals, spark plugs and timing components prior to installation.
- Refill engine oil, transmission gear oil and coolant to manufacturer-specified capacities before initial cranking.
- Prime the lubrication system and verify ECU wiring pinouts, sensors, and ground connections.
- Our 2-year warranty covers internal lubricated components, cylinder heads and engine block from delivery, in addition to your statutory rights.
Full terms: 2-year warranty · returns