Notice Some of our inventory is overstock and customer returns, priced below retail. The condition of every unit is stated on its listing.
Inspecté et Rapport d'État Fourni Fret Palettisé Assuré UK et Europe
+44 7451 259592 [email protected]
0
2018 Evinrude E-TEC 30 HP E30DRS Outboard Motor
Inspected & Documented Condition notes recorded before palletizing.
30-Day Startup Warranty Covers block, heads and internal moving components.
In Stock & Ready to Freight Outboard Motors

2018 Evinrude E-TEC 30 HP E30DRS Outboard Motor

Brand: Evinrude
Condition: New
€2,067.65
Freight included, insured road freight within the UK & Europe (rates)
€2,067.65 delivered across UK & Europe
  • ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
  • Insured European road freight delivery with hydraulic tail-lift service
  • Dispatches in 1–2 business days from our UK & European Logistics Centre
  • Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Ask a question about this unit

Need a matched transmission, controls or wiring package? Speak with a parts specialist.

Details & Inspection Notes

The 2018 Evinrude E30DRS shares its 149.91-pound dry weight with a rope-start, manual-trim sibling, both on the short 15-inch shaft of this 30 HP line, built for buyers prioritizing simplicity.

Specifications on the rope-start build

Bore comes to 2.992 inches and stroke to 2.5 inches on this two-cylinder E-TEC, for a total of 577 cc, shifting through a 2.15:1 gear ratio with RPM climbing from 5,500 up near 6,000 at full throttle. Both starting and trim are handled entirely by hand, by cord and by lever, with no powered hardware involved at all.

Fitment and fluids to check

A transom suited to a 15-inch shaft is what this build is sized for, so measure before ordering rather than assuming the mounting bracket on hand will fit without checking. Fuel is 87-octane unleaded gas, and Evinrude/Johnson XD-100 is the recommended oil. The alternator reserves 15 of its 56 total amps net dedicated, cooling runs on raw water, and the engine carries a saltwater rating.

Condition

This is a new E30DRS, not used or refurbished, and it ships as the bare powerhead and controls rather than bundled with a boat, battery, or steering cable, leaving rigging choices entirely to the buyer. What's the dry weight? 149.91 pounds. Can it be run offshore? It is rated for saltwater use.

Specifications

MODEL E30DRS
MODEL YEAR 2018
SKU E30DRS
WEIGHT 149.91 lb
MANUFACTURER Evinrude
COUNTRY OF MANUFACTURE United States
HORSEPOWER 30hp
SHAFT LENGTH 15″ (Short)
STEERING Tiller
STARTING Manual
TRIM & TILT Manual
FUEL DELIVERY E-TEC Direct Injection with stratified low RPM combustion mode
FUEL TANK External
CYLINDER(S) 2
DISPLACEMENT 577 cc (35.2 cubic inches)
BORE AND STROKE 76 mm x 64 mm (2.992 x 2.5 inches)
FULL THROTTLE RPM RANGE 5,500-6,000 RPM
FUEL TYPE Unleaded Gasoline (87 octane)
OIL TYPE Evinrude / Johnson XD-100 Oil
OIL CAPACITY 1.7 qt (1.6 L)
LUBRICATION Multi-Point Targeted Oiling
ALTERNATOR 56 Amps Total / 15 Amps Net Dedicated
COOLING SYSTEM Water Cooled
SALTWATER RATED Yes
GEAR RATIO 2.15:1
GEAR SHIFT Forward, Neutral, Reverse

Startup & Installation Checklist

  • Inspect all external gaskets, seals, spark plugs and timing components prior to installation.
  • Refill engine oil, transmission gear oil and coolant to manufacturer-specified capacities before initial cranking.
  • Prime the lubrication system and verify ECU wiring pinouts, sensors, and ground connections.
  • Startup warranty covers internal lubricated components, cylinder heads, and engine block for 30 days from delivery.

Full terms: 30-day startup warranty · returns

More Outboard Motors

View all outboard motors