In Stock
Inspected & Documented
Condition notes recorded before palletizing.
30-Day Startup Warranty
Covers block, heads and internal moving components.
In Stock & Ready to Freight
Auto Parts & Accessories
AMD 920-1370-L/R Taillight Panel Reinforcement Brackets (2 Piece Set), 1970-76 Duster, Demon, Dart Sport
€42.74
+ freight from €89.00, insured road freight, priced by delivery region
(rates)
From €131.74 delivered
- ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
- Insured European road freight delivery with hydraulic tail-lift service
- Dispatches in 1–2 business days from our UK & European Logistics Centre
- Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Need a matched transmission, controls or wiring package? Speak with a parts specialist.
Details & Inspection Notes
This listing bundles AMD's left and right taillight panel reinforcement brackets, part numbers 920-1370-L and 920-1370-R, into one two-piece set sized for the 1973-1976 Dodge Dart Sport, 1970-1976 Plymouth Duster and 1971-1972 Dodge Demon. Each bracket weighs about 2 lbs and is built to factory specifications and finished in EDP coating.
What each bracket does
On its side of the car, each bracket spans between the taillight panel above and the trunk floor below, tying the two together, and it also doubles as a jack-support point. Because the bracket ties two structural areas together, a failed one can affect both the trunk floor and how the taillight panel sits.
One design, three model lines
Demon, Duster and Dart Sport share this same bracket design across the years listed here, so confirm your specific model and year fall within that range before ordering rather than assuming by body style alone. Since this is a matched left-and-right set, you get both sides in one order.
Common questions
Do I need to order left and right separately? No, this listing is the matched two-piece set covering both sides.
What does the bracket attach to? It attaches to the trunk floor extension and the taillight panel.
Performance Installation & Verification Checklist
- Disconnect vehicle battery ground terminal before installing any electrical, sensor, or powertrain hardware.
- Inspect all vacuum lines, fuel lines, and wiring harness connectors for secure, leak-free engagement.
- Calibrate electronic sensors, boost control solenoids, and ECU maps according to manufacturer instructions.
- Perform initial datalogging check under light load before subjecting vehicle to wide-open throttle.
Full terms: 30-day warranty · returns
