In Stock
1967-1968 Firebird Tail Lamp Panel
- ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
- Insured European road freight delivery with hydraulic tail-lift service
- Dispatches in 1–2 business days from our UK & European Logistics Centre
- Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Need a matched transmission, controls or wiring package? Speak with a parts specialist.
Details & Inspection Notes
This is an OE-style reproduction tail lamp panel for a 1967-1968 Firebird, made by Dynacorn, a manufacturer that has built classic-era sheet metal, trim and molding since 1984. It is sized to restore the rear tail lamp area to its original shape.
Who it suits
Restorers working on a 1967 or 1968 Firebird whose factory tail lamp panel has rusted, cracked or been cut for non-stock lighting will find this panel replaces that section with new, correctly shaped steel rather than patched original metal.
Fit and finish
Dynacorn builds this part from new tooling, so panel lines and mounting points are made to match the factory profile for the 1967-1968 Firebird. As with any reproduction sheet metal, plan for trial fitting, trimming and welding by someone experienced with classic muscle car bodywork.
What years does this panel fit? 1967 and 1968 Firebird.
Is this an original GM part? No, it is a new OE-style reproduction.
Performance Installation & Verification Checklist
- Disconnect vehicle battery ground terminal before installing any electrical, sensor, or powertrain hardware.
- Inspect all vacuum lines, fuel lines, and wiring harness connectors for secure, leak-free engagement.
- Calibrate electronic sensors, boost control solenoids, and ECU maps according to manufacturer instructions.
- Perform initial datalogging check under light load before subjecting vehicle to wide-open throttle.
Full terms: 30-day warranty · returns