In Stock & Ready to Freight Outboard Motors

Tohatsu 9.9HP MFS9.9EEPS Outboard Motor

Part no: MFS9.9EEPS
Brand: Tohatsu
Condition: New
€1,773.94
Freight included, insured road freight within the UK & Europe (rates)
€1,773.94 delivered across UK & Europe
  • ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
  • Insured European road freight delivery with hydraulic tail-lift service
  • Dispatches in 1–2 business days from our UK & European Logistics Centre
  • Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Ask a question about this unit

Need a matched transmission, controls or wiring package? Speak with a parts specialist.

Details & Inspection Notes

This spec listing for the Tohatsu 9.9HP MFS9.9EEPS covers a 15-inch shaft with remote mechanical steering rather than a tiller, electric start backed by manual, and a weight of 102 lbs on the 333cc EFI engine used across this outboard family.

Short shaft, console steering

Pairing a 15-inch shaft with remote mechanical steering is a less common combination among the outboards covered in this batch, since most remote-steer versions here run longer shafts; this one suits a boat with a shorter transom that's also rigged for console steering rather than a tiller handle. Full throttle runs between 5400 and 6100 rpm, the same strong top end shared across this EFI engine family regardless of shaft length or steering type.

What to confirm before ordering

Because this is a remote-steering configuration, you'll need a steering cable and console setup already in place or planned, rather than mounting a tiller handle on this motor later. This particular spec sheet doesn't list a separate equipment section, so confirm fuel tank and line needs on your own rather than assuming they ship with it. Double-check your transom height against the 15-inch figure too, since shaft length can't be adjusted once the motor is mounted. Warranty on this unit runs 5 years.

Is this tiller-steered? No, steering is remote mechanical.

Shaft length? 15 inches, the short option.

Startup & Installation Checklist

  • Inspect all external gaskets, seals, spark plugs and timing components prior to installation.
  • Refill engine oil, transmission gear oil and coolant to manufacturer-specified capacities before initial cranking.
  • Prime the lubrication system and verify ECU wiring pinouts, sensors, and ground connections.
  • Startup warranty covers internal lubricated components, cylinder heads, and engine block for 30 days from delivery.

Full terms: 30-day startup warranty · returns