Miller Suitcase 12RC with Bernard Q300 Gun, Meters, Remote Voltage (951580)

Built to keep a production line moving instead of stopping for roll changes, this wire feeder (951580) takes 12-inch spools and pairs them with an air-cooled Bernard Q300 gun rated for 300 amps at a full duty cycle, on a 15-foot cable.

What it is built for

This is an industrial, career-welder-level feeder for MIG and flux-cored wire, able to handle diameters up to 5/64 inch. Its case is sealed, impact-resistant, and flame-retardant, keeping moisture, dust, and shop debris away from the wire and electronics, and the design is meant to be carried to a remote welding station rather than bolted to one spot.

Before buying

The feeder itself weighs 25.5 pounds, runs on 110V, and is rated for 100 percent duty at 500A on the feed side. This RC-style feeder needs a 14-pin connector cable to link up to a compatible power source — check that you already have one, since it is not part of this listing. Drive rolls swap with no tools, and the unit shuts itself down automatically if airflow is restricted or duty cycle runs over what it is rated for.

Standard on this feeder

Remote voltage control and a gas solenoid are both built in rather than options added later, and the carry handle folds flat against the case until a gloved hand needs it.

Is this feeder meant to travel between job sites? Yes, it is built light and balanced for exactly that.

Three-year Miller warranty applies to this unit.

Specifications