Miller Multimatic 220 Ac/Dc Welder + Spectrum 375 Plasma Cutter (907757, 907529)

Add plasma cutting to a MIG/stick/TIG welder without a separate order: this package pairs the Multimatic 220 AC/DC with a Spectrum 375 X-treme cutter, and the welder itself arrives fully equipped rather than needing extra torches or controls bought afterward.

What each half covers

The 220 AC/DC handles MIG to 3/8-inch steel or aluminum, DC stick to 3/8-inch steel, and AC/DC TIG to 1/4-inch steel or aluminum, with QuickTech sensing polarity and switching processes automatically as you work. The Spectrum 375 brings its own power source, a 12-foot hand torch, a work clamp on a matching 12-foot cable, a cord with dual-voltage plugs, a carrying case, and a consumables box with electrodes, tips, a deflector, and an air fitting.

Before wiring it in

Both halves run on 120V or 240V through plugs that need no tools to swap, so check available outlets first. The welder's 14-pin port accepts a pedal, fingertip, or cordless remote, and dual gas connections keep MIG and TIG supplies ready at the same time rather than forcing a swap mid-job.

Welder accessories included

Beyond the plasma cutter hardware above, the welder itself ships fully loaded: its own gun, torch, pedal, dual flow regulators, wire and tips, a drive roll, an accessory kit, and a thickness gauge all come in the same crate.

Does the cutter need a separate gas supply? No, the Spectrum 375 is an air-plasma unit and does not rely on shielding gas the way the welder does.

Three-year Miller warranty on the welder side of this package.

Specifications