In Stock
2018 Tohatsu 20 Hp MFS20EEFTS Outboard Motor
- ISPM 15 heat-treated Euro palletized & weatherproof shrink-wrapped
- Insured European road freight delivery with hydraulic tail-lift service
- Dispatches in 1–2 business days from our UK & European Logistics Centre
- Transit typically 1–3 business days (UK) / 3–6 business days (Continental Europe)
Need a matched transmission, controls or wiring package? Speak with a parts specialist.
Details & Inspection Notes
The 2018 Tohatsu MFS20EEFTS combines a 15-inch short shaft with power tilt and electric start on the EFI version of the 20 hp tiller platform, aimed at larger or heavier skiffs, jon boats, and inflatables where a shorter shaft fits the transom better than a long one does.
Short shaft, powered trim
Power tilt lets you raise or lower the motor at a switch rather than a hand lever, which matters most on heavier boats where trimming by hand takes more effort; shaft length is still set by your transom, not by your trim preference. This EFI engine's top end runs from 5,000 through 6,000 rpm.
Fuel and electrical
Fuel comes from its own tank, roughly 3 gallons or 12 liters, piped in through a dedicated hose rather than a shared design across the lineup, and an aluminum propeller rounds out the hardware up front. A 12-volt, 12-amp alternator does the charging while electric start handles ignition, and the motor is cleared for saltwater.
Q: Does going short-shaft cost any power? No, displacement, induction, and the electrical system carry over unchanged; only the shaft length moves, decided entirely by your transom measurement.
Tohatsu backs the MFS20EEFTS with a 5-year warranty. With power tilt and EFI both drawing on the electrical system, periodically check the alternator's output and the tilt motor's wiring for corrosion, especially after saltwater use.
Specifications
| MODEL | MFS20EEFTS |
| MODEL YEAR | 2018 |
| SKU | MFS20EEFTS-18 |
| WEIGHT | 116.0000 |
| MANUFACTURER | Tohatsu |
| COUNTRY OF MANUFACTURE | Japan |
| HORSEPOWER | 20hp |
| SHAFT LENGTH | 15″ (Short) |
| STEERING | Tiller |
| STARTING | Electric |
| TRIM & TILT | Power Tilt |
| FUEL DELIVERY | EFI |
| FUEL TANK | External |
| CYLINDER(S) | 2 |
| DISPLACEMENT | 333 cc (20.32 cu. in.) |
| BORE AND STROKE | 61 57 mm (2.4 x 2.24 in.) |
| FULL THROTTLE RPM RANGE | 5,000-6,000 RPM |
| IGNITION SYSTEM | No |
| INDUCTION SCAVENGING | No |
| VALVES PER CYLINDER | No |
| FUEL TYPE | Unleaded Gasoline (87 Octane) |
| FUEL TANK / FUEL LINE | 3 gal. (12 liter) Separate Tank |
| OIL TYPE | Tohatsu 4 Stroke Outboard Motor Oil |
| OIL CAPACITY | No |
| LUBRICATION | No |
| ALTERNATOR | 12V-12A |
| COOLING SYSTEM | Water-Cooled, Thermostatically Controlled |
| SALTWATER RATED | Yes |
| GEAR RATIO | 2.15 |
| GEAR SHIFT | F-N-R |
| PROPELLER | 3 blade aluminum |
| INTERNAL BATTERY | No |
Startup & Installation Checklist
- Inspect all external gaskets, seals, spark plugs and timing components prior to installation.
- Refill engine oil, transmission gear oil and coolant to manufacturer-specified capacities before initial cranking.
- Prime the lubrication system and verify ECU wiring pinouts, sensors, and ground connections.
- Startup warranty covers internal lubricated components, cylinder heads, and engine block for 30 days from delivery.
Full terms: 30-day startup warranty · returns